Murray Fidan
- Total activity 60
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 34
Articles
Recent activity by Murray Fidan-
Shelf hardware - too hard to push in or pull out
Try opening up the width of the route on the edge of the wood. Try 10 to 10.5mm by running your 3/8" router 2 times with a 1mm offset. Another thing you can try is going shallower than 10mm deep...
-
Starboard & Phenolic E900BM or E900BMMini Keyhole Slot
To avoid chipping re-melt and difficulty cleaning out the keyhole slot in plastic or phenolic dense material try doing two passes, the first with a 5mm Acrylic bit the second with the Lockdowel bit...
-
Routing in Dense material like Phenolic
Since our router bit was designed to route in wood. Routing in dense plastic may reduce the tool's life. Here are some recommendations to prolong the tool's life. • Lower the feed rate• Use a plast...
-
Routing in Plastic
Since our router bit was designed to route in wood. Routing in plastic may reduce the tool's life. Here are some recommendations to prolong tool life. • Lower the feed rate• Use a plastic router bi...
-
Back Panel Diagrams and Drawings
-
Typical Fastener Location & Depth
-
Feeds & Speeds for Lockdowel Router Bit
What are the correct feeds and speeds for Lockdowel Router Bits Technical data for our router bits and all other products is located in our online catalog. Router Bit Data Online Catalog Link. http...
-
Factory Quality Posters
-
There is a gap in my Lockdowl Hclip Joints
Reason Solution The depth of route is too deep, the depth of route should be 10.6mm deep. Measure panel thickness before sending files to the CNC Machine. Check to make sur...
-
Can I use a manual horizontal boring machine with Lockdowel?
Insert 8mm drill bits in all the tool holders on the manual boring machine and drill all holes. Set the left and right fence up to match where the first hole drills. Manually insert the fasteners i...