Murray Fidan
- Total activity 60
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 34
Articles
Recent activity by Murray Fidan-
Feeds & Speeds for Lockdowel Router Bit
What are the correct feeds and speeds for Lockdowel Router Bits Technical data for our router bits and all other products is located in our online catalog. Router Bit Data Online Catalog Link. http...
-
Factory Quality Posters
-
There is a gap in my Lockdowl Hclip Joints
Reason Solution The depth of route is too deep, the depth of route should be 10.6mm deep. Measure panel thickness before sending files to the CNC Machine. Check to make sur...
-
Can I use a manual horizontal boring machine with Lockdowel?
Insert 8mm drill bits in all the tool holders on the manual boring machine and drill all holes. Set the left and right fence up to match where the first hole drills. Manually insert the fasteners i...
-
Can I use a manual horizontal boring machine with Lockdowel HClips?
Yes, insert 8mm drill bits in all the tool holders on the manual boring machine and drill all holes 27mm deep. Set the left and right fence up to match the first hole offset. Manually insert the fa...
-
The horizontal panels do not line up with the face of the assembly.
REASON Horizontal boring machine is not drilling accurately from fence stops. SOLUTION Check the calibration and/or fence stops on your horizontal boring machine. REASON Edgebanding is being t...
-
There is a gap in my panel joints
REASON The depth of the route is too shallow, the depth of route should be 9mm. Channel Lock is not inserted flush into the edge of the part. SOLUTION Measure panel thickness before sending files t...
-
It is too hard to slide my parts together
REASON The depth of the route is too deep, the depth of the route should be 9mm. SOLUTION Measure panel thickness before sending files to the CNC Machine. Check to make sure the tool length is corr...
-
Checking calibration for H-Clip in CV.
To check your machine calibration when using H-clips: Cut several square test panels on your CNC. We suggest not cutting them on a table saw. Cut your test parts small enough to not waste material,...
-
General Functions and Construction Methods using Cabinet Vision