
Thomas May
- Total activity 56
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 32
Activity overview
Latest activity by Thomas May-
Thomas May created an article,
-
Thomas May created an article,
-
Thomas May created an article,
Product Specifications and User Manual
Download the Lockdowel User Manual here:
-
Thomas May created an article,
Checking calibration for H-Clip in CV.
To check your machine calibration when using H-clips: Cut several square test panels on your CNC. We suggest not cutting them on a table saw. Cut your test parts small enough to not waste material,...
-
Thomas May created an article,
Lockdowel Cabinet Vision Channel Lock and HClip Boring Spacing CENTER Point Positions V12 & V2021
The workbooks in the attached excel spreadsheet who the CENTER position for the Channel Lock or HClip fasteners.
-
Thomas May created an article,
-
Thomas May created an article,
-
Thomas May created an article,
Microvellum
https://community.microvellum.com/portal/kb/community
-
Thomas May created an article,
Nylon Fasteners Compliance with Prop65
Proposition 65 Proposition 65, officially known as the Safe Drinking Water and Toxic Enforcement Act of 1986, was enacted as a ballot initiative in November 1986. The proposition protects the state...
-
Thomas May created an article,
Shelf hardware - too hard to push in or pull out
Try opening up the width of the route on the edge of the wood. Try 10 to 10.5mm by running your 3/8" router 2 times with a 1mm offset. Another thing you can try is going shallower than 10mm deep...